Презентация на тему Picasso M- User Debug mode Flash ROM Procedure (only for nonfused device)

USB driver to local disk.
Unzip the image pack and

USB driver to C:/
Make sure of tablet device had full charging before ROM flashing.

SOP

off on tablet device.
Pressing and holding Volume up +

down key simultaneously
To stick the RESET button and let device enters to flashing mode.
Release Volume Up/Down keys.

2. USB driver installation (only for first time of connecting)
Connected PC and device via USB cable.
PC will auto-detect the device and ask to install USB driver.
On PC installing wizard, to select manual installing mode, then to indicate where of the driver (unzipped driver folder in C://) and finish the driver installation.
Keeping on connection condition (PC – Tablet).

[nvflash_Acer_AV041_A510_RV28RC03_EMEA_GB(Debug for non-fused device).7z] to C://
To make sure of

the following files in folder
=> flash.bct
=> flash.cfg
=> bootloader.bin
=> boot.img
=> system.img
=> recovery.img
(=> userdata.img)
(=> flexrom.img)
Double click "!Flash.bat ” and pc will pop-up DOS command mode window.
Flash start…. (Success case will show the flashing process on pc)
!!Failed Case!! If you did not see any processing on command mode at start, please repeat again 1. Enter to Flash mode and connecting PC, and then 3. ROM flash.