Презентация на тему CoDeSys CNC functionality

for control and regulation of machine (CNC machines), or

the equipment used (controller, computer).

The set-up and the numerical address of the sending control information is described in DIN 66025/ISO 6983, usually referred to DIN / ISO programming. DIN A program can run on any CNC machine. However, for almost all machine specific commands, such as cycles, which can only be interpreted by these machines. Cycles are global programs, with parameters / variables that can be used where "pockets" (square contours or similar bags) or describe holes etc.. This makes the programming cycles and increase the clarity.

programming geometric motion profiles SoftMotion supports parts of the

CNC language DIN66025. Since the whole SoftMotion concept is embedded in the much more powerful language IEC61131, only those parts of DIN66025 are supported, which serve to create a path.

Prescribed structure of a CNC program:
N G
Example:
% MyExample
N10 G01 X100 Y100 E100 F100 E-200
N20 G01 Z40 F20
N30 G03 X-100 R200 F100

in linear and circular movements:








Supported by: C5 with CoDeSys

V2.3
C6 with CoDeSys V3.4 (COMBIVIS studio)

of tool or workpiece in several
Working planes. However you

can coordinate not more then two axis
In their movements at the same time.






Supported by: C5 with CoDeSys V2.3
C6 with CoDeSys V3.4 (COMBIVIS studio)

movements of tool or workpiece. All
three axis have a

functional interpolation.







Supported by: C6 with CoDeSys V3.4 (COMBIVIS studio)